A wide variety of technologies are available on the market. However, to find an economically and ecologically efficient solution it is important to have knowledge of these technologies and then to carefully select the appropriate application. Ciba EHS-Services typically use the following stages for the best possible results:

STEPS FOR AN OPTIMAL SOLUTION

Situation Analysis
EHS-Services always starts work with a thorough analysis of the specific situation. If data is missing or cannot be calculated, we measure key parameters or guide analytical work as necessary.
More information

Target Definition: This stage results in a clear picture of the situation combined with a well defined target, which is elaborated upon in close cooperation with the customer. These are the key factors required for a good technical solution.

The technical concept largely determines the cost and success or failure of the project. Thus EHS-Services strongly focus work on this key element. We evaluate the feasibility of technical alternatives based on our vast expertise, experience with similar situations and on rough cost estimates. Case study: considerable VOC-reduction at low cost

Treatability studies, laboratory or pilot testing may be necessary in order to strengthen the basis for the technical concept. We have the capability to do this work in-house, at the customers site or to guide and assess external testing.

Basic engineering can be done with a higher or lower degree of technical information and cost accuracy, based on the customers needs.

Detailed planning, tender evaluation and supplier selection, implementation and start-up:
EHS-Services deliver a range of support upon customers request.

A VARIETY OF CASE STUDIES
illustrating our broad experience
you can find in our  Waste Water  and Waste Gas pages

For more examples also see our
Environmental Services Annual Review 2006
where you find highlights of last years project work

CUSTOMER TESTIMONIAL
from

Syngenta Crop Protection